Monthly Archives: September 2019

USTMamiya Recoil ESX Golf Iron Shaft Review

Leave a reply

UST Mamiya Recoil ESX Shaft Review

By Russ Ryden, Fit2Score, A Dallas Fort Worth Club Fitter & Club Maker
The Highlands Performance Golf Center, Carrollton Texas 
Golf Digest Certified America’s 100 Best Club Fitter

 

It has been some time since I measured a set of UST Mamiya Recoil iron shafts. UST does not make review samples available and the last time I did measure a set of constant weight taper Recoils I did not see consistent profiles through the set. Updates to a fitting cart that arrived a few weeks ago included the Recoil ESX. I ordered a set of irons that were getting custom shafted with uncut ESX shafts to get an updated look at set consistency. I pulled the shafts and measured them. I was suprised with what I saw.

To read this review, you must register . 

If you want to truly understand golf shafts, register for an annual subscription of $10. Ten dollars is less than the cost of a sleeve of premium golf balls or a bucket of range balls. Your support will keep Golf Shaft Reviews going and growing. This website is the only comprehensive information source about golf shafts available to the public. I do not receive compensation from the shaft companies nor clutter the site with ads.

The technical section of the site is open to all. In it you can learn about the terms and concepts discussed in the reviews.

Information provided at registration will NEVER be shared with ANYONE. To be notified of new reviews, follow DevotedGolfer on facebook.

Enjoy and Good Golf,
Russ

Oban CT-125 Golf Shaft Review

Leave a reply

Oban CT-125 Iron Shaft Review

By Russ Ryden, Fit2Score, A Dallas Fort Worth Club Fitter & Club Maker
The Highlands Performance Golf Center, Carrollton Texas 
Golf Digest Certified America’s 100 Best Club Fitter

The Oban CT-125 is the last of the weights that will be made in this model. It joins the previously reviewed CT-100 and CT-115, completing the fitting matrix of the series. Each weight has 11 shafts from which the club builder can select a subset to build a set. The extended range allows for fine tuning stiffness by “soft stepping” or “hard stepping”. This is not exactly the correct term for this design, but it is a concept you may be familiar with. Building a set of 8 shafts from the 11 available allows for three steps in either the soft or hard direction. A smaller set of 6 or 7 irons adds more stiffness options. Most other constant weight shaft brands produce 8 or 9 shafts in a model matrix.

If you do not follow my YouTube Channel, Devoted Golfer, this was shot at the 2019 PGA Merchandise show. Ralph Reichart, owner of Oban talks about briefly about the extrusion process used by Shimada to make the CT series of iron shafts. 

To read this review, you must register . 

If you want to truly understand golf shafts, register for an annual subscription of $10. Ten dollars is less than the cost of a sleeve of premium golf balls or a bucket of range balls. Your support will keep Golf Shaft Reviews going and growing. This website is the only comprehensive information source about golf shafts available to the public. I do not receive compensation from the shaft companies nor clutter the site with ads.

The technical section of the site is open to all. In it you can learn about the terms and concepts discussed in the reviews.

Information provided at registration will NEVER be shared with ANYONE. To be notified of new reviews, follow DevotedGolfer on facebook.

Enjoy and Good Golf,
Russ